SM20 Adhesive

SM20 Adhesive

SM20 Contact Adhesive

Technical Information
Size 500ml / 15 oz
Category Stick on Wall Solutions
Product Name Size Unit Price Qty. Sub Total
SM20 Adhesive (only for use with SM20 panels) 500ml / 15 oz £6.25 £0.00
Delivered separately by courier.
Volume discounts apply automatically.
Generally only shipped with our SM20 walls panels


Product Summary

SM20 Adhesive is a very high strength contact adhesive.

High Strength Bond Achieved in Minutes
Excellent Grab
Good Heat Resistance
Long Open Time
Versatile
BS476 Part 7 Class 1 Approved
Building Regulations: Class 0
Wheelmark Accredited
SAFT Heat Tested 100˚C


Product Application

Using the adhesive

Before using the special adhesive, read the directions on the back of the can then proceed as follows; Shake can well before using. For best results, the ambient temperature should be 21°C/70°F and well ventilated Ensure all surfaces to be bonded are free from oil, grease, dirt, dust, and any other material that may affect the bond. Adjust the nozzle by turning to the largest spray pattern which is usually the third symbol to the right looking at the top of the can and near the base of the nozzle. Hold the can 6 to 8 inches away from surface and apply in even coats making sure the adhesive webs across the surface. Take care not to use too much adhesive or you may run out before the end of the job.

Do not hold closer than 6 inches or wet the surface. It is important a web pattern is obtained and at least 80% of the surface is covered. One surface should be sprayed vertically and the other horizontally. Do not concentrate in one spot or allow to puddle. Once both surfaces have been coated, bond the sound insulation directly to the wall with a firm, even pressure. Tack time can vary depending on climate conditions and may well be shorter or none at all if it is warm. In warm conditions, the adhesive may go off before bonding commences if too much time is taken before bonding the two surfaces together so don’t delay. It is important that good pressure is applied to ensure a firm bond is obtained. A roller may help. Although our adhesive is low odour, it is still advised that where the work is being conducted is well ventilated with a window open if possible. The adhesive should be stored at normal room temperatures of 15° - 21°C.

Occasionally, for various reasons, problems may be encountered bonding the product to the wall. When this occurs, mechanical fixings can be used in addition to the adhesive as follows: If fixing to plasterboard faced timber stud, additional normal wire nails hammered well into the insulation so the heads are below the panel surface work well. In these cases use only sufficient nails to secure the insulation effectively. When fixing to masonry walls nail guns can be used to shot fire nails through the insulation or alternatively, masonry nails combined with battens can be used but these must be removed when the adhesive has cured.



Instructions for use

The safety data sheet, the technical data sheet and product certificates can be found on the manufacturers website.

Tuskbond Logo

 
 

Add a review